Open a freezer that is working properly and you might see a little frost here and there. Open one with a problem and you might find packages welded together, a fuzzy white layer coating the back wall, or a ridge of ice around the door. These are not all the same problem. Where the frost forms, and what type of freezer you have, points to very different causes.
Where frost comes from
Frost is moisture from the air that freezes on cold surfaces. Every time a freezer door opens, warm room air enters, and the moisture in it freezes onto whatever is coldest. In a humid Long Island August, each door opening carries in more moisture than it would in winter. Any leak in the door seal does the same thing continuously.
What happens to that frost depends on the freezer.
- Manual-defrost freezers — many chest freezers and some compact uprights — do nothing about it. Frost slowly accumulates on the walls or cooling plates, and you are expected to defrost the freezer yourself periodically.
- Frost-free freezers — most refrigerator-freezers and many uprights — have a defrost system: a heater, a thermostat or sensor, and a timer or control that melts frost off the cooling coil several times a day, then drains the water away. You should not see significant frost build up in a frost-free freezer.
So the first question is which kind you have. Your manual or the model sticker will say.
Manual-defrost freezers
If you have a chest freezer, gradual frost on the walls is expected. Many manuals suggest defrosting when the frost reaches a certain thickness — often a fraction of an inch — because thick frost acts as insulation and makes the freezer work harder.
To defrost a manual freezer:
- Move the food to coolers or another freezer, packed together to stay cold.
- Unplug the freezer.
- Open the drain plug if it has one, and place a pan under the outlet.
- Leave the lid open and let the frost melt. Some manuals allow a pan of hot water inside to speed things up.
- Do not chip at the frost with a knife or a screwdriver. It is very easy to puncture the cooling lines in the walls.
- Dry the inside, close the drain, plug it back in, and let it cool before restocking.
Frost that builds much faster than it used to in a chest freezer usually means air is getting in — check the lid gasket and make sure the lid closes fully.
Frost-free freezers: read the pattern
Frost on food packages and loose ice crystals
Frost on the packages themselves, especially near the door, usually means air is getting in. The door may not be closing fully, the gasket may be torn or deformed, or the door is being opened very often. Food that was put away warm, or not wrapped tightly, also releases moisture that freezes inside the package.
Ice around the door edge
A ridge of ice along the door gasket strongly suggests the seal is leaking at that spot. Wipe the gasket clean with warm soapy water; a sticky gasket can pull away from the cabinet. Then test it by closing the door on a dollar bill at several points. If the bill pulls out with no drag, the gasket is not sealing there. Also check that the freezer is level and the door closes on its own, and that nothing in the freezer — an ice tray, a package sticking out — is propping it open.
A thick, even layer of frost on the back wall
This is the classic sign of a defrost system failure. In a frost-free freezer, the cooling coil is usually hidden behind a panel at the back. When the defrost system stops working, frost builds up on the coil until it shows through the vents and spreads across the back panel. The freezer slowly loses its ability to cool, and in a refrigerator-freezer the fresh-food side often warms first. Our post on a cold freezer over a warm fridge walks through that pattern.
Common causes are a failed defrost heater, a failed defrost thermostat or sensor, or a fault in the defrost timer or control board. A full manual defrost — unplugging the unit with the doors open for a day — will temporarily restore it, but the frost comes back within days or weeks if the defrost system is not repaired.
Ice on the floor of the freezer
Ice in the bottom of the freezer, often under the drawers or bins, usually comes from the defrost drain. If the drain is clogged or frozen, meltwater from the defrost cycle refreezes in the compartment instead of draining away. This sometimes happens alongside a defrost system problem.
What you can do yourself
- Check and clean the gasket, and test the seal.
- Level the freezer so the door closes on its own.
- Reorganize so nothing blocks the door or vents.
- Defrost a manual freezer properly.
- Do a manual defrost of a frost-free freezer as a temporary measure — just be prepared for it to return if the defrost system is the cause.
When to call
Call a technician when frost keeps building on the back wall of a frost-free freezer, when the drain keeps freezing, or when the door seal is damaged and needs replacing. Diagnosing a defrost system means removing interior panels and testing parts, and on newer models reading the control board.
If you are worried about food that has thawed partially while you sorted this out, our post on freezer food safety after a power outage covers how to judge what to keep. You can book a freezer repair visit or read about our freezer repair service across Nassau and Suffolk.