Skip to main content

Phones answered 24/7 · Long Island, NY

Washers · 6 min to read

The Little Door at the Bottom of Your Front-Loader: Cleaning the Drain Pump Filter

Most front-load washers have a filter that catches coins, hair ties and lint before they reach the pump. When it clogs, the washer stops draining. Here is how to clean it without flooding the laundry room.

Written by PrimeFix Long Island

If your front-load washer has finished a cycle with water still sitting in the drum, or it stops mid-cycle with a drain error, there is a good chance the fix is a few minutes away and needs no tools at all. Most front-load washers have a drain pump filter — sometimes called a coin trap or debris filter — behind a small door or panel at the bottom front of the machine. It is there to catch the things that fall out of pockets before they reach the pump. When enough of them collect, water cannot get out.

Many owners never open it, and some do not know it exists. It is worth learning before the day you need it.

What the filter catches

Over months of laundry, the filter collects lint and fabric fibers, coins, hair ties, bobby pins, buttons, small socks, tissues, and the occasional underwire from a bra. Pet hair is a big contributor in homes with dogs or cats. In coastal parts of Long Island, beach sand from towels and swimsuits adds to it in summer. Any of these can slow or stop draining, and a hard object can damage the pump impeller if it gets past the filter.

Before you start

  • Check your manual. The location and design vary. Most are behind a hinged or snap-off panel at the lower front, left or right. A few machines have the filter behind the full lower kick panel. Your manual will show where yours is and whether it has a separate small drain hose.
  • Let hot water cool. If the washer just stopped during a hot cycle, the water inside can be hot enough to scald. Wait until it has cooled.
  • Turn the washer off and unplug it.
  • Gather supplies. Several old towels, a shallow baking dish or a low pan, and a bucket. Front-loaders sit low to the floor, so a normal bucket will not fit under the filter.
  • Expect more water than you think. If the washer stopped full, there may be several gallons in it. You will be draining it a dish at a time.

Draining and cleaning, step by step

  1. Lay towels on the floor in front of the machine and open the access panel.
  2. If there is a small drain hose next to the filter, pull it out, hold its end over your pan and remove its cap. Let the water drain, cap it when the pan is full, empty the pan, and repeat. This is slow, but it gives you control.
  3. If there is no separate hose, put the pan under the filter and turn the filter cap counterclockwise just a little. Water will start to seep out around it. Close it when the pan fills, empty, and repeat.
  4. When water stops coming out, unscrew the filter the rest of the way and pull it out. Expect a final gush of water and some unpleasant debris.
  5. Rinse the filter under the tap and pull off anything wrapped around it.
  6. Look into the opening with a flashlight. Remove anything you can see, and if your manual says it is safe to do so, gently turn the pump impeller with a finger to check it spins freely. Do not use tools to pry at it.
  7. Screw the filter back in fully, until it is snug and seated in the same position it came out. Push the drain hose back in and close its cap firmly.
  8. Close the panel, plug the washer in, and run a rinse-and-spin or drain cycle while watching the filter area for drips.

A slow drip at the filter after reassembly almost always means it is cross-threaded or not fully tightened. Drain it again, remove it, and reseat it carefully.

How often to do it

Manufacturers' recommendations vary — some say every few months, others only when you see a drain problem. A reasonable habit is to check it every couple of months, and more often if you wash pet bedding, work clothes or lots of sandy beach towels. Doing it before the washer is full of water is much easier than doing it after.

If cleaning the filter did not fix it

When the filter is clean and the washer still will not drain, the cause is somewhere else in the drain path:

  • The drain hose. A kinked hose behind the washer, especially after it has been pushed back against the wall, can stop drainage. So can a hose that is pushed too far down into the standpipe.
  • The standpipe or laundry drain. If water backs up out of the standpipe or a nearby laundry sink while the washer drains, the clog is in the house drain, not the washer. That is a plumbing issue.
  • The pump. A pump that hums but does not move water may be jammed by something beyond the filter, or the motor may have failed. A pump that is silent during the drain portion of the cycle may not be getting power.
  • The control or a pressure sensor. On some machines, a failed water-level sensor or control fault can produce a drain error even when the drain path is clear.

These are the points where a technician can test the pump and control and give you a clear answer.

A note on top-loaders

Most top-load washers do not have a filter that owners are meant to open; their pumps are reached from underneath or behind. If your top-loader will not drain, check the drain hose and standpipe, and look in your manual for any listed filter, but do not take the cabinet apart unless the manual walks you through it.

Preventing the next clog

  • Empty pockets every time, and zip zippers and fasten hooks before washing.
  • Wash small items, like baby socks and bras, in a mesh laundry bag.
  • Shake sand out of beach towels outside before they go in.
  • Use the right amount of high-efficiency detergent; excess suds can slow draining on some machines.

If your front-loader has a musty smell as well as a drain problem, our post on why front-loaders smell worse in Long Island summers covers the door gasket and the cleaning cycle. If the washer still is not draining after all of this, you can book a washer repair visit, or read more about our washer repair service across Nassau and Suffolk.

Continue with

Call now(631) 729-9995Book online