Ducted to the outside
The air is pushed through a duct — out through the top of the microwave into a duct in the cabinet above, or out through the back into the wall — and then outside. This removes heat, moisture, smoke and odours from the house.
Recirculating
There is no duct. The air passes through a grease filter and a charcoal filter, and is blown back into the kitchen through vents above the door. This traps some grease and odour, but it does not remove heat or moisture.
How to tell which you have
- Look at the top of the cabinet above the microwave for a duct.
- Check the outside wall behind the kitchen for a vent hood.
- If air blows out of the grille above the microwave door when the fan runs, it is almost certainly recirculating.
Many over-the-range microwaves can be installed either way, and installers often choose recirculating because there is no duct path. If you are remodelling, it is worth asking whether ducting to the outside is possible.
The grease filters
All over-the-range microwaves have metal grease filters on the underside. They trap airborne grease before it reaches the fan and the inside of the cabinet.
Manufacturers such as GE recommend cleaning grease filters about once a month, or when a filter indicator says so. Most can be removed by sliding or pulling them out of the underside. Soak them in hot water with a degreasing dish detergent, scrub gently, rinse and dry them fully before reinstalling. Check your manual before putting them in the dishwasher; some manufacturers allow it, some caution against it.
Never run the fan without the grease filters in place. Grease will coat the fan and the inside of the microwave.
The charcoal filter (recirculating only)
If your microwave recirculates, it also has a charcoal filter, usually behind the grille at the top front. It absorbs odours. Charcoal filters cannot be washed — they must be replaced. Common guidance is every six to twelve months, depending on how much you cook. Signs it is due: cooking smells linger, or the filter looks greasy.
If your microwave vents outside, it should not have a charcoal filter in the airflow. Some installations have one left in by mistake, which restricts airflow.
Why this matters for the microwave
Grease that gets past dirty filters builds up on the fan, in the airflow path and around the microwave's internal components. Over time that can:
- Make the fan noisy or slow.
- Cause the microwave to run hotter, because the cooling airflow is blocked.
- Create a fire hazard if grease builds up heavily.
Many over-the-range microwaves also have a feature that turns the vent fan on automatically if it detects heat from the cooktop. That is normal — it is protecting the electronics above.
Faults you might see
The fan does not run, or runs on one speed only
This is often a fan motor, a switch or a control board issue. Check first that the grease filters are not completely blocked.
The fan runs on its own and will not turn off
Many models do this automatically when the cooktop below is hot. If the cooktop is off and cool and the fan still runs, it may be a sensor or control fault.
The light under the microwave does not work
Usually a bulb, but the bulb type is specific to the model. Check the manual for the correct replacement.
The microwave does not heat
That is the microwave part of the unit rather than the vent, and it is a different set of components — magnetron, diode, capacitor, door switches.
A safety note: do not open the cabinet
Microwave ovens contain a high-voltage capacitor that can hold a dangerous charge even after the microwave is unplugged. Do not remove the outer cabinet or attempt internal repairs yourself. Filters, bulbs and cleaning are user tasks; everything inside is not.
Also, an over-the-range microwave is heavy and is supported by a wall bracket and bolts through the upper cabinet. If it is sagging, tilting forward or the door no longer closes properly, have it checked before it comes down.
If you are replacing one
Over-the-range microwaves are commonly built to fit a 30-inch-wide space above a range, but heights, depths and mounting brackets vary between models. A replacement usually comes with its own wall plate and template, and the old bracket is rarely a perfect match. Before you buy:
- Measure the space between the cooktop and the bottom of the upper cabinet, and check it against the new model's installation guide, which sets the minimum clearance above the cooking surface.
- Confirm whether you will vent outside or recirculate, and that the new model supports that setup.
- Check that there is a properly located outlet in the cabinet above. Many installation guides specify a grounded outlet in that cabinet.
- If the existing duct is in the top of the cabinet, check where the new model's exhaust opening sits so it lines up.
A poorly fitted over-the-range microwave can pull loose from the wall over time, so mounting it properly matters as much as choosing it.
Quick maintenance schedule
- Clean grease filters monthly.
- Replace the charcoal filter every six to twelve months if you recirculate.
- Wipe the underside of the microwave and the grilles regularly.
- Run the vent fan whenever you cook on the range, and for a few minutes after.
If your fan has stopped, the microwave is not heating, or something sounds wrong, book a visit for microwave repair.